Analisis Turbin Hidrokinetik Savonius Biomimetik Berbasis Kontur Tubuh Ikan Haruan (Channa striata) pada Kecepatan Aliran Rendah
DOI:
https://doi.org/10.32497/jmeat.v4i2.7659Keywords:
biomimetic, hydrokinetic, moment coefficient, snakehead fishAbstract
This study aims to investigate the effect of a biomimetic blade design based on the body contour of the snakehead fish (Channa striata) on the torque characteristics of a Savonius hydrokinetic turbine. The biomimetic concept was applied to the turbine blade geometry to evaluate its potential for improving hydrodynamic performance compared with a conventional Savonius turbine. The research was conducted using Computational Fluid Dynamics (CFD) simulations by comparing the moment coefficient (Cm) distribution as a function of rotor angular position for both biomimetic and conventional turbine configurations. The analysis was performed over a complete rotor revolution to identify torque generation characteristics and the influence of blade geometry on turbine performance. The results show that both turbine configurations exhibit similar moment coefficient distribution patterns, with the maximum moment coefficient occurring at rotor angles of approximately 30°–40° and the minimum moment coefficient occurring at rotor angles of approximately 110°–130°. However, the conventional Savonius turbine demonstrated superior performance compared with the biomimetic design. The maximum moment coefficient of the conventional turbine reached approximately 0.35, whereas the biomimetic turbine achieved only about 0.20. In addition, the biomimetic turbine produced a more negative minimum moment coefficient of approximately −0.40 compared with −0.30 for the conventional turbine. These findings indicate that the snakehead fish-inspired blade geometry employed in this study has not yet enhanced the rotor's torque-producing capability nor effectively reduced the adverse effect of the returning blade. Nevertheless, the proposed biomimetic concept remains promising and warrants further investigation through optimization of blade profile, blade orientation, overlap ratio, aspect ratio, and operating conditions to achieve improved hydrokinetic turbine performance
References
I. E. AGENCY, Renewables. International Energy Agency, 2024.
M. Altan, B. D., & Atilgan, “The use of a curtain design to increase the performance level of a Savonius wind rotors,” Renew. Energy, vol. 35, no. 4, pp. 821–829, 2010.
K. Eksperimental, T. Air, and D. T. Menggunakan, “Jurnal Pendidikan Teknik Mesin Undiksha,” vol. 9, no. 2, pp. 109–123, 2021, doi: 10.23887/jptm.v9i2.29257.
W. B. Power, “Waterotor Energy Technologies Inc. -,” no. March, 2012.
J. Arifin and M. Pauzan, “ENHANCED PERFORMANCE OF THE GORLOV HYDROKINETIC TURBINE,” vol. 18, no. 1, pp. 19–25, 2024, doi: 10.24853/sintek.18.1.19-25.
Rendi, S. Ihsan, and S. Ma’arif, “Turbin Air Arus Sungai Model Sudu Propeller Menggunakan Nozzel-Diffuser,” J. Engine, vol. 4, no. 1, pp. 27–33, 2020.
T. Antomo, I. M. Kamiana, and D. A. Nindito, “Analisis pengembangan hidrokinetik turbin gorlov akibat penambahan luas bidang tangkap,” Tek. J. Sains dan Teknol., vol. 16, no. 2, p. 159, 2020, doi: 10.36055/tjst.v16i2.9186.
V. N. Chaudhari and S. P. Shah, “Numerical investigation on the performance of an innovative Airfoil-Bladed Savonius Hydrokinetic Turbine ( ABSHKT ) with deflector,” Int. J. Thermofluids, vol. 17, no. January 2023, p. 100279, 2027, doi: 10.1016/j.ijft.2023.100279.
R. Rendi, B. Hatradi, M. Irfansyah, and P. Puteri, “Desain Underwater Rotor Untuk Memanfaatkan Laju Aliran Sungai Sebagai Pembangkit Listrik Tenaga Air,” J. Engine Energi, Manufaktur, dan Mater., vol. 5, no. 2, p. 77, 2021, doi: 10.30588/jeemm.v5i2.888.
D. S. Khais and B. Ariani, “Seminar Nasional TREnD Analisa Kinerja Savonius Hydrokinetic Turbine Menggunakan Metode Computational Fluid Dynamic Pada Studi Kasus Sungai Pemali , Tegal , Jawa Tengah,” 2022.
H. J. et al Vermaak, “Status of micro-hydrokinetic river technology in rural applications,” Renew. Sustain. Energy Rev., vol. 29, pp. 625–633, 2014.
R. Iliev, G. Todorov, and K. Kamberov, “Evaluation of the Performance of Optimized Horizontal-Axis Hydrokinetic Turbines,” pp. 1–22, 2025.
E. Paniagua-garcía, E. Taborda, and C. Nieto-londoño, “A meta-model based cross-sectional shape of a Savonius hydrokinetic turbine for sustainable power generation in remote rural areas,” Renew. Energy, vol. 244, no. August 2024, p. 122647, 2025, doi: 10.1016/j.renene.2025.122647.
D. Parameters and S. Hydrokinetic, “Numerical and Experimental Investigation of the Effect of,” 2022.
Yao, F. Li, J. Chen, Z. Yuan, and W. Mai, “Parameter Analysis of Savonius Hydraulic Turbine Considering the E ff ect of Reducing Flow Velocity,” 2020.
Downloads
Published
Issue
Section
License
Copyright (c) 2026 rendi rendi

This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
Copyright of articles that appear in Journal of Mechanical Engineering and Applied Technology belongs exclusively to Penerbit Jurusan Teknik Mesin Politeknik Negeri Semarang. This copyright covers the rights to reproduce the article, including reprints, electronic reproductions, or any other reproductions of similar nature.



