Analisis Injeksi Epoxy Pada Perbaikan Retak Beton Terhadap Beban Lentur
DOI:
https://doi.org/10.32497/wahanats.v23i2.1360Abstract
One of the causes of cracking in concrete beams is excessive gravitational load,
mainly due to live loads that exceed capacity. The cracked beam can be repaired by the epoxy injection method but the condition of the repair is the strength value must reach the condition before cracking. The purpose of this study was to determine the effectiveness of injection in filling cracks and assessing epoxy ability in restoring beam strength. The specimen is a f'c 25 reinforced concrete block with dimensions of 15x15x60 cm. Tests are carried out with 2 methods, that are loading test according to SNI 03-4154-1996 and UPV. Load test and UPV were carried out at the age of 28 days and 3, 6. 9 days after epoxy injection. Based on the load test, epoxy injection is able to restore beam flexural strength up to 50% which is indicated by achieving load values after being injected. From the UPV test, it is known that epoxy injection is able to fill cracks which are characterized by increasing ultrasonic wave propagation speed on the test object after injection compared to when cracked but the injection cannot completely fill the cracked area which is indicated by a smaller wave propagation value than when the object the test has not experienced a crack. Based on a series of research activities, it is very necessary to pay attention to the injection process such as viscosity and injection pressure in order to obtain good results.
Kata kunci : crack, injection, epoxy
References
Griffin, Sarah dkk., 2017, “Evaluation of Epoxy Injection Method for Concrete Crack Repair”, International Journal of Structural and Civil Engineering Research Vol. 6, No. 3, August 2017.
Nalini.S. dkk, 2017, “Experimental Study on Epoxy Injection on Concrete”, International Journal of Mechanical Engineering and Technology (IJMET), Volume 8, Issue 12, December 2017, pp. 227”“234, Article ID: IJMET_08_12_023
Soebandono, Bagus dkk., 2011, “Perbaikan Balok Beton Bertulang dengan Metode Jacketing dengan Bahan Ferosemen Akibat Beban Siklik pada Beban Ultimit”, Jurnal Ilmiah Semesta Teknika, Vol. 14, No. 2, Hlm. 166-176.
Downloads
Published
Issue
Section
License
Authors who publish with this journal agree to the following terms:Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).