Proses Permesinan Non Konvensional Dengan Abrasive Water Jet Machining Untuk Material Keramik

Authors

  • Sisworo (Jurusan Teknik Mesin Politeknik Negeri Semarang)

DOI:

https://doi.org/10.32497/teknis.v11i1.680

Abstract

The process of cutting material is reshaped by cutting. Non conventional cutting process is needed to overcome the shortcomings in the previous process is conventional. For ceramic type material that has properties; hard, strong and setabil at high temperatures, but brittle and easily broken or cracked. Emphasis on the brittle material resulted in local crack follow devormasi elastic. With the abrasive water jet machining (AWJM) technology is cutting the material with tap 4.2 bar mixture of 70% water and 30% abrasive able to overcome the shortcomings of conventional process.

Keywords: AWJM, cutting of ceramic materials

Downloads

Published

2016-04-05

Issue

Vol. 11 No. 1 (2016): TEKNIS, April 2016

Section

Articles

License

Authors who publish with this journal agree to the following terms:

Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a  Creative Commons Attribution License  that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.

Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.

Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See  The Effect of Open Access).